Projectlog Entries List

Lachat run LTER Lysimeter 20260402. Notes from run:

• Three vials labeled T3 R3 1, 2, and 3 were ran as T5 R3 1, 2, and 3. Flasks for T3 R3 and T5 R3 were swapped when evacuating samples. Weights were adjusted when entering in data file to the correct location, but vials were sampled incorrectly.

Lachat run LTER Lysimeter 20260319. Notes from run:

• Vial labeled T2 R4 1 should not exist, not enough volume listed. Ran as Vial T3 R4 1, that was not present and should exist.
• Vial T CF R2 1 missing from box, not run (no data notes)
• Vial T6 R3 3 present, should not exist. Not enough volume in vial to run.

Weigh LTAR plants - Jon, Jordyn

Sort ASP1 forage - Emily, Brian, Bella, Jon, Sam, Olivia

Pack CN - Sam, Bella

Dishes, lab clean-up - Jordyn, Glori

NAS vial prep and data entry - Olivia

Measure and filter LTAR leachate, filter LTER soil extracts, LTAR and BCSE gas vial prep - Jordyn, Glori, Emily, Brian

Sort ASP1 forage - Sam, Jon

Sieve LTER soil -

Weigh LTER soil for extraction and moisture - Alyssa,

Sort ASP1 forage, empty ovens - Alyssa

Make new LTER gas vials; all previous vials are awaiting analysis due to troubles with the old GC and switch over to a new GC - Alyssa, Olivia

Measure and filter LTER leachate - Sam, Jordyn, Glori

Reshake then filter LTER T3, T4 soil extracts - Emily, Brian

Prep LTAR gas vials, totes - Jordyn, Glori

Weigh T3, T4 soil for extraction, moisture and T21 whirlpaks (90-100g/whirlpak) - Olivia, Brian, Jordyn

BCSE gas tote prep, dishes - Jordyn, Brian

LTAR 16 gas sampling and Hydrosense - Bella, Glori, Sam, Brian, Emily

NAS gas and Hydrosense sampling - Olivia

Install T3 tall flags and T-posts - Jon, Jordyn

Cut T1, T2 corn paths - Emily, Olivia, Jon, Bella, Brian, Stacey

LTAR gas chamber prep - Brian, Jon, Sam

Sticky traps - Brian, Emily

Collect LTAR leachate - Sam, Jon

BCSE 11 gas sampling and Hydrosense - Emily, Glori

Dishes - Jordyn

Measure and filter LTAR leachate - Sam, Glori

Filter LTER soil extracts - Jordyn, Jon

BCSE gas chamber prep, then evacuate LTAR lysimeters - Emily, Brian

Sticky traps - Jon, Sam, Emily

Bury T21 soil bags. Bury whirl-paks in their corresponding plot. Measure or pace ~7m in a NE direction from the SW corner of each plot. At that point, place a meterstick perpendicular to the tape measure at the 50cm mark on the meterstick. Bury T21 A at one end and T21 B at the opposite end. In corn and poplar plots, the spacing should be adjusted to ensure both bags are buried within a row of wheat or poplars. Each bag gets buried over an orange garden marker at about a 45-degree angle with the top of the bag about 1” below the surface and the marker sticking out of the ground 1-2”. For removal in 21 days - someone can pull up on the orange marker to easily remove the bags. For burial, use a trowel or narrow shovel to lift the soil, place the marker and bag, and then remove the trowel and press down the soil to ensure contact with the buried bag. Try to disturb the plants as little as possible. A flag is placed at the 50cm point midway between the buried bags to help in locating them later. In T1-4 the flag should be in a corn row between the buried bags with all bags and flags within a row of corn. Wherever helpful, tie flagging tape on a plant above the flag, so it is easily located for collection.

• Emily, Brian, Jon, Sam, Glori, Stacey

Weigh LTER soil for extraction, moisture and T21 incubation - Glori, Jordyn, Brian around 11

BCSE and LTAR gas vial prep - Jordyn

The added REX radios caused the RF407 network to go into a nework storm. I turned off T7R4, R5, R3 and R1. The network traffic went back to normal. I restarted T7R1 and it's stable so far.

Prepared standards, Acid washed dishes.

Lachat run LTER soil 06052023